Mammoth aims to reduce up to 60% of the shock and vibration transmitted to the powerhead during normal drilling operational practices, with no maintenance required between service/repair intervals. Patent Pending

18” Shock Sub

24” Shock Sub

28” Shock Sub

34” Shock Sub

34” Shock Sub

18 inch shock sub repairable 24 inch shock sub repairable   28 inch shock sub repairable   28 inch shock sub repairable 1 34 inch shock sub repairable 2 

 

*The percentages and figures reflected are estimates based on testing of the product and are not guaranteed results. The percentages of improvement will vary depending on factors such as rock type, rock abrasiveness, ground water and drilling parameters.

 

EXAMPLE OF REPAIR KIT (COMPONENTS MAY VARY)

SPLIT PIN | Quantity: 8

RUBBER | Quantity: 1

RUBBER SEAL | Quantity: 1

LINK | Quantity: 8

 SPLIT PIN  RUBBER  RUBBER SEAL  LINK

Part No: MT-SP-45-18

Part No: MT-RDB-18-02

Part No: MT-RS-18

Part No: MT-LK-18-02

FLANGE | Quantity: 1

PIN | Quantity: 8

NUT | Quantity: 16

O-RINGS | Quantity: 2

 FLANGE  PIN  NUT  O RINGS

Part No: MT-ST-18

Part No: MT-P-45-85-18

Part No: MT-CN-M24

Part No: MT-52-OR

BOLT | Quantity: 4

NUT | Quantity: 4

NUT | Quantity: 4

NUT | Quantity: 4

 BOLT  NUT 2  NUT 3  NUT 4

Part No: MT-B-M30-65

Part No: MT-NN-M30

Part No: MT-MN-M45-T

Part No: MT-MN-M45-B

 

It is advised to replace wear parts every 4000 - 6000 hours depending on drilling conditions to maintain peak performance. It is recommended that only genuine parts and consumables are used on the Mammoth Product range, to ensure full performance and stability during operation.

*The percentages and figures reflected are estimates based on testing of the product and are not guaranteed results. The percentages of improvement will vary depending on factors such as rock type, rock abrasiveness, ground water and drilling parameters.